Content Introduction Getting started Scanning and building Import and export Recognition Inclusions Optimization Reports Laser marking Common features

Laser marking How to do Laser Marking? Checking shift of stone position during laser marking Safety laser marking option Batch laser marking mode Marking line adjustment algorithm removes unnecessary marking lines Bound Marking Option Laser marking offset for girdle form marking Draw Girdle profile instead of Girdle curve Culet marking lines Export set of burning lines into separate file *.bdl from Pacor Client and mark it on Helium Rough New laser marking control of hardware

previous   top   next Batch laser marking mode Batch mode of laser marking allows to burn a set of marking lines automatically. New batch mode of laser marking is implemented since version 4.55: The batch laser marking mode reduces time of marking Safety of marking process is significantly increased due to reducing of stones damages: cracks on surface, breaks of stone during marking and etc There was a problem in previous versions. Marking in batch mode is not stopped with previous scanner hardware controllers in a moment during pressing of STOP button or opening the cover. Marking stops after completion of commands batch. It is approximately 3-5 sec after pressing of STOP or opening the cover. The problem is fixed with new hardware controller and new batch mode. To use new batch mode is necessary to replace hardware controller with new one to let software stop marking in a moment after pressing of STOP button or opening the cover. Besides replacement of controller allows to make marking process quitter. For replacement of hardware controller please contact distributor in your region.   previous   top   next