Content Introduction Getting started Scanning and building Import and export Recognition Inclusions Optimization Reports Laser marking Common features

Scanning and building Scanning overview What model to use: shadow or laser mapping ? Preparation for scanning Preparation a stone before set into scanner Set holder plane Set dashed frame - plane of glue correction Scanning Creating shadow model Checking accuracy of constructing a model Creating Laser Mapping model Other options Checking shift of stone position during scanning Getting photos (obsolete) Offline work with series of photos

previous   top   next Offline work with series of photos To work without hardware with series of photos switch to Manual mode in the panel Status, press button: After this operation two new buttons will appear in the Scene panel: Photo and Series. Photo button switches on / switches off is a possibility of changing of photos by mouse. Note, it starts work if at least one photo is loaded in the Scene panel. So, if button switched on it allows rotate object by mouse and automatically load photo during rotation in accordance with position of model. For this operation it is necessary in opened project (model should be present) press Series button and select one bmp file from folder (all images will be loaded in the memory of system from this folder). Button Photo will be switched on automatically and allow rotating photos. Then move mouse cursor to the border of Scene and cursor will modified for this one (move cursor not far then 64 pixels from any border of scene). Then user can rotate model and photos pressing and holding the left button of mouse. Please, take into account that Photo series list is not saved in mmd file and after you load new project you need load series of photos again.   previous   top   next