Content Introduction Getting started Scanning and building Import and export Recognition Inclusions Optimization Reports Laser marking Common features

Recognition Recognition Parameters for recognition Rough models resembling

previous   top   next Recognition Recognizing project is required when your diamond is not reset on its main position. i.e. may be removed from stage during any process. For recognize project try to recognize older model and newer model with its medium, without Laser Mapping Model. So, it is easy to find better facets on both model. It can be possible that sometimes both models are recognize directly by software but this is not done every time. Since version HR 4.33 new recognition option is available. It allows to recognize project more fast and accurate. To use recognition option: Open some mmd file Select from menu Start / Recognition project Panel Start / Recognition project appears Select another correspondent mmd file to recognize it and import its inclusions, layers, etc and select mmd`s model on the right side of the panel Recognition project Press button Open Panel Recognition appears Select Preparatory stage option and Main stage option. Preparatory stage option allows to use preliminary matching of the models with combine models approximately Main stage option allows to use main matching of the models witch combine models precisely. But this option works only if models already approximately combined Button Run starts selected matching of the model To recognize model press button Run If Preparatory stage option did not work the follow message is displayed Preparatory stage can't done In this case we advise to switch off the Preparatory stage option, combine the model manually and press button Run again to use Main stage option only If Main stage option did not work the follow message is displayed Main stage can't done In this case we advise to switch off the Main stage option and press button Run again to use Preparatory stage option only To import inclusions, layers, etc from recognized project press OK The inclusion will be imported, panel Recognition closed and recognized 3D model destroyed. Note. To use old recognition algorithm from previous release before 4.33 set Old Recognition = 1 in the Registry.   previous   top   next