Content Introduction Getting started Scanning and building Import and export Recognition Inclusions Optimization Reports Laser marking Common features

Laser marking How to do Laser Marking? Checking shift of stone position during laser marking Safety laser marking option Batch laser marking mode Marking line adjustment algorithm removes unnecessary marking lines Bound Marking Option Laser marking offset for girdle form marking Draw Girdle profile instead of Girdle curve Culet marking lines Export set of burning lines into separate file *.bdl from Pacor Client and mark it on Helium Rough New laser marking control of hardware

previous   top   next Safety laser marking option The laser marking does not draw lines near any type of defects. It allows to avoid small micro cracks near defects appearing because of tensions. This option provides more safety for stone while laser marking process. The safety distance is 100 microns from the edges of defect. The drawing stops at distance 100 microns before defect and continues at distance 100 micron after defect. Please see example of laser marking line on the image: The OXG File with Plotted Inclusion and Plan Real Image of the Inclusion (Crack) before Marking Image of the Stone after Marking (With Paint) The value of safety distance could be changes by administrator. Please ask your distributor in the case of need. Note. Please make sure that all defects should be placed in the defect list in Env page of Marking-out panel if you would like to apply this option for them.   previous   top   next